ASTM-D5154 Standard Test Method for Determining Activity and Selectivity of Fluid Catalytic Cracking (FCC) Catalysts by Microactivity Test

ASTM-D5154 - 2018 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determining Activity and Selectivity of Fluid Catalytic Cracking (FCC) Catalysts by Microactivity Test
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This test method covers determining the activity and selectivity of either equilibrium or laboratory deactivated fluid catalytic cracking (FCC) catalysts. The activity is evaluated on the basis of mass percent conversion of gas oil feed in a microactivity unit. The selectivities are evaluated on the basis of mass percent yields of specifically defined products resulting from the catalytic cracking of gas oil feed.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

5.1 The microactivity test provides data to assess the relative performance of FCC catalysts. Because results are affected by catalyst pretreatment, feedstock characteristics, test equipment, and operating parameters, adherence to this test method is a prerequisite for correct interpretation of results. Apparatus, test conditions, and analytical procedures actually used should closely resemble those described in this test method. Significant variations in apparatus, test conditions and/or analytical procedures may result in activity and selectivity data which do not correlate with data developed by other laboratories on identical catalyst/feedstock samples.

5.2 The standard method reaction temperature is 516 °C [960 °F]. Other reaction temperatures can be used; however, catalyst selectivity data developed at temperatures other than 516 °C [960 °F] may not correlate with selectivity data developed at 516 °C [960 °F]. Also, precision at other reaction temperatures may change compared to data obtained at 516 °C [960 °F].

Keywords

catalysts; FCC; fluid cracking catalyst; MAT; microactivity; selectivity;

To find similar documents by ASTM Volume:

05.05 (Combustion Characteristics; Manufactured Carbon and Graphite Products; Catalysts)

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

71.040.30 (Chemical reagents Including reference materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5154/D5154M-18

Revision Level

2018 EDITION

Status

Current

Modification Type

Revision

Publication Date

May 1, 2018

Document Type

Test Method

Page Count

9 pages

Committee Number

D32.04