ASTM-D5162 › Historical Revision Information
Standard Practice for Discontinuity (Holiday) Testing of Nonconductive Protective Coating on Metallic Substrates
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers procedures for determining discontinuities using two types of test equipment:
1.1.1 Test Method A--Low Voltage Wet Sponge, and
1.1.2 Test Method B--High Voltage Spark Testers.
1.2 This practice addresses metallic substrates. For concrete surfaces, refer to Practice D4787.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses immediately following inch-pound units are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
discontinuity; high voltage; holiday; holiday detectors; low voltage; new linings; wet sponge type instruments; spark testers; ICS Number Code 25.220.20 (Surface treatment)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5162-01
Revision Level
2001 EDITION
Status
Superseded
Publication Date
June 10, 2001
Document Type
Practice
Page Count
4 pages
Committee Number
D01.46