ASTM-D5180 › Standard Test Method for Quantitative Test for Turbidity in Clear Liquids (Withdrawn 2007)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of turbidity of clear liquids. It is applicable to resin solutions, solvents, clear coatings, monomers, and any other liquids where clarity is specified. This test method should be used only for comparison of clarity of similar materials, and not to obtain absolute values for turbidity.
1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
clarity; cloudiness; resin clarity; resin turbidity; turbidity; ICS Number Code 71.040.40 (Chemical analysis)
To find similar documents by ASTM Volume:
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Document Number
ASTM-D5180-93
Revision Level
1993 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
May 15, 1993
Document Type
Test Method
Page Count
2 pages
Committee Number
D01.33