ASTM-D520 › Standard Specification for Zinc Dust Pigment
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers three types of zinc dust, for use as a pigment in paints. The pigments shall consist substantially of metallic zinc and shall conform to the requirements for composition prescribed. The total and metallic zinc shall be shall be tested to meet the requirements prescribed. Lead, cadmium, and iron shall be tested to meet the requirements prescribed. Oily or fatty matter, or both shall, and the coarse particle shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers three types of zinc dust, for use as a pigment in paints.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
pigment; zinc;; ICS Number Code 87.060.10 (Pigments and extenders)
To find similar documents by ASTM Volume:
To find similar documents by classification:
87.060.10 (Pigments and extenders)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASME-HST-5Performance Standard for Air Chain Hoists
MIL-C-26482
Connectors, Electrical, (Circular, Miniature, Quick Disconnect, Environment Resisting)
CGA-C7
Guide to Classification and Labeling of Compressed Gases
Document Number
ASTM-D520-00(2019)
Revision Level
2000 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2019
Document Type
Specification
Page Count
2 pages
Committee Number
D01.31