ASTM-D5393 Test Method for Determination of Fogging Characteristics of Vehicle Interior Trim Materials (Withdrawn 1998)

ASTM-D5393 - 1997 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Test Method for Determination of Fogging Characteristics of Vehicle Interior Trim Materials (Withdrawn 1998)

Scope

1.1 This test method covers a procedure for determining the tendency of interior trim materials used in automobiles and other vehicles to produce a light-scattering film, which may be called fog film or fog, on a glass surface in a controlled environment.

1.2 Acceptance criteria for materials tested using this test method will be established by the specifications of those companies that implement this test method.

1.3 This procedure is applicable to the measurement of fog condensate on glass surfaces within the limits of the test conditions. This test will not measure or cannot measure accurately those cases in which:

1.3.1 The condensate's surface tension is low, resulting in early coalescing into a thin transparent film.

1.3.2 The condensate is present in such large quantity that the droplets coalesce and form a heavy oily/clear film on the glass surface. This heavy film would result in false glossmeter readings during the final evaluation.

1.3.3 The condensate is reactive within the vehicle environment or interactive with other volatiles in the vehicle not present in the test chamber.

1.4 All testing on compounds indicated herein is based on materials conditioned in a controlled atmosphere of 23 + 2°C and 50 + 5% relative humidity for 24 h prior to any testing and tested under the same controlled conditions.

Note 1-This standard and ISO 6452 are essentially equivalent.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Note 4 for a specific hazard statement.

Keywords

automobiles; fog-film; fogging; interior-trim materials; light-scattering film; plasticizers; vehicles; volatile ingredients

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5393-97

Revision Level

1997 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

July 10, 1997

Document Type

Test Method

Page Count

7 pages

Committee Number

D20.15