ASTM-D5432 › Historical Revision Information
Standard Performance Specification for Blanket Products for Institutional and Household Use
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the evaluation of specific performance characteristics of importance in thermal woven, conventional woven, flocked, nonwoven, and knitted blanket products for use in institutional and household environments.
1.2 This specification may be used by mutual agreement between the purchaser and the supplier to establish purchasing specification requirements.
1.3 The requirements in Table 1 apply to the length and width directions for those properties where fabric direction is pertinent.
1.4 This specification does not include requirements for electric blankets. Electric blankets are specified under UL 964 requirements dictated by the Underwriter's Laboratories.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Characteristic | Requirements | |||
---|---|---|---|---|
Knits/Flock | Woven/Nonwoven | Section | ||
Breaking Force (CRT | . . . | 89 N (20 lbf) min | 7.1.1 | |
method)A | ||||
each direction | ||||
Bursting force, | 345 kpa (50 psi) min | 7.1.2 | ||
(ball burst)A | ||||
Dimensional change: | ||||
After 5 launderings | 7.2.1 | |||
each direction | ||||
Wool (50 % or more) | 6.0 max | 6.0 max | ||
Cotton | 5.0 max | 5.0 max | ||
All others | 3.5 max | 3.5 max | ||
After 3 drycleanings | 7.2.3 | |||
each direction | ||||
All fabrics | 3.5 max | 3.5 max | ||
Colorfastness:B | ||||
Laundering: | 7.3.1 | |||
Shade Change | Grade 4C min | Grade 4C min | ||
Staining | Grade 3D min | Grade 3D min | ||
Drycleaning | 7.3.2 | |||
Shade Change | Grade 4C min | Grade 4 C min | ||
Crocking: | 7.3.3 | |||
Dry | Grade 4E min | Grade 4E min | ||
Wet | Grade 3E min | Grade 3E min | ||
Light (20 AATCC | Step 4C min | Step 4C min | 7.3.4 | |
AFU, xenon-arcA) | ||||
Flammability | Class I | Class I | 7.4 | |
Laundered | AcceptableF | AcceptableF | 7.5.1 | |
Appearance |
A There is more than one standard method that can be used to measure breaking force, bursting force, and lightfastness. These methods cannot be used interchangeably since there may be no overall correlation between them (see Notes 2-5, and 8).
B Grade for color change and color transfer is based on a numerical scale of 5 for negligible or no color change or color transfer to 1 for severe color change or color transfer. The numerical rating in Table 1 or higher is acceptable.
C AATCC Gray Scale for Color Change.
D AATCC Gray Scale for Staining.
E AATCC 9-Step Chromatic Transference Scale.
F As agreed upon between the purchaser and the supplier.
Significance and Use
Upon mutual agreement between the purchaser and the supplier, woven products intended for this end use should meet all of the requirements listed in Table 1 of this specification.
It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements in Table 1. Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and the supplier.
In such cases, any references to the specification shall specify that: This product meets Specification D5432 except for the following characteristic(s).
Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2, ultimate consumer demands dictate varying performance parameters for any particular style.
The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.
Keywords
ICS Number Code 97.160 (Home textiles. Linen)
To find similar documents by ASTM Volume:
07.02 (Textiles (II): D4393 - latest)
To find similar documents by classification:
97.160 (Home textiles. Linen Including duvets, blankets, bedding Electric blankets, see 97.030)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5432-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Reinstate with Revision
Publication Date
March 31, 2012
Document Type
Specification
Page Count
3 pages
Committee Number
D13.63