Document Center is acquired by Nimonik

Scope

1.1 This specification covers poly(methyl methacrylate) rods, tubes, and other shapes produced by casting or machining cast blanks. This specification does not apply to heat-formed and molded or extruded parts and shapes, or sections that are made by assembling or joining two or more pieces.

Note 1-The properties included in this specification are those required to identify the types and grades of materials covered. There may be other requirements necessary to identify particular characteristics.

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2-There is no similar or equivalent ISO standard.

Keywords

acrylic; acrylic plastic; cast acrylic; clear weatherable plastics; plastic; plastic materials; plastic rods; plastic shapes; plastic tubes; PMMA; poly(methyl methacrylate); rods; shapes; transparent; tubes; ICS Number Code 83.140.99 (Other rubber and plastic products)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.140.99 (Other rubber and plastics products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.