ASTM-D5624 › Standard Practice for Determining the Transverse-Aggregate Spread Rate for Surface Treatment Applications (Withdrawn 2022)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice details the procedure for determining the aggregate spread rates in approximately 0.33-m transverse increments.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This practice can be used to calibrate aggregate spreaders and verify the uniformity of distribution transversely prior to construction of the surface treatment by determining the average quantity of aggregate spread per unit area.
4.2 This practice can be useful for quality control during construction to monitor the spread rate.
4.3 The samples obtained during construction can also be used for the determination of moisture content and grading when such information is required.
Keywords
aggregate spread rate; surface treatment
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5624-13
Revision Level
2013 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Jan. 15, 2014
Document Type
Practice
Page Count
3 pages
Committee Number
D04.24