ASTM-D564 › Standard Test Methods for Liquid Paint Driers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the test procedures to be applied to liquid paint driers used in paints and related coatings. Typical paint driers, listed in Specification D600, are carboxylates of lead, cobalt, manganese, zinc, iron, calcium, and zirconium.
1.2This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Driers accelerate the drying of oil, paint, printing ink, and varnish.
These test methods are applicable to liquid driers manufactured for use in paints and related coatings.
The tests for metallic content using ethylenediaminetetraacetic acid dihydrate (EDTA) are intended for concentrated solutions of single metals; two or more metals may cause interference.
Keywords
driers; standard test; liquid paint driers; ICS Number Code 87.060.99 (Other paint ingredients)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
87.060.99 (Other paint ingredients)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D0564-87R23
Revision Level
1987 R23 EDITION
Status
Current
Publication Date
July 28, 2023
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.21