ASTM-D5662 › Historical Revision Information
Standard Test Method for Determining Automotive Gear Oil Compatability with Typical Oil Seal Elastomers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the compatibility of automotive gear oils with specific nitrile, polyacrylate, and fluoroelastomer oil seal materials.
1.2 Users of this test method should obtain Test Methods D 412, D 471, and D 2240 and become familiar with their use before proceeding with this test method.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
compatibility; elastomer; elongation change; gear oil; hardness change points; oil seal; volume change; ICS Number Code 43.060.30 (Cooling systems. Lubricating systems)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
43.060.30 (Cooling systems. Lubricating systems Antifreezes, see 71.100.45 Lubricants, see 75.100)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5662-06
Revision Level
2006 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 1, 2006
Document Type
Test Method
Page Count
19 pages
Committee Number
D02.B0.03