ASTM-D5679 › Standard Practice for Sampling Consolidated Solids in Drums or Similar Containers
The following bibliographic material is provided to assist you with your purchasing decision:
Changes from the previous issue
A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.
Scope
1.1 This practice covers typical equipment and methods for collecting samples of consolidated solids in drums or similar containers. These methods are adapted specifically for sampling drums having a volume of 110 U.S. gal (416 L) or less. These methods are applicable to hazardous material, product, or waste. Specific sample collection and handling requirements should be described in the site-specific work plan.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
auger; chipper; consolidated solids; hazardous waste; rotating corer sampling; thin-wall tube ;; ICS Number Code 13.030.40 (Installations and equipment for waste disposal and treatment)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5679-16
Revision Level
2016 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 15, 2016
Document Type
Practice
Page Count
5 pages
Committee Number
D34.01.02