Document Center is acquired by Nimonik

Scope

1.1 This specification covers machine-made reinforced thermosetting epoxy resin pipe and fittings nominal pipe size (NPS) 2 in. (50 mm) through 12 in. (304 mm) diameter to be used for continuous service in condensate return lines for the specific maximum temperature and pressure covered by this specification, 250°F (121°C) and 125 psig (862 kPa).

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are provided for information purposes only.

1.3 The dimensionless designator NPS has been substituted in this specification for such traditional terms as "nominal diameter", "size", and "nominal size".

1.4 The following safety hazards caveat pertains only to the test method portion, Section 10, of this specification:

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Boil resistance; Centrifugally cast pipe-plastic; Condensate return lines; Cycling resistance; Epoxy resins-pipe/fittings; Glass-fiber-reinforced thermosetting resin ("fiberglass"); Impact resistance; "fiberglass"pipe/pipe fittings (adhesive bonded joint type epoxy resin),; for condensate return lines (NPS 2 to 12 in. (50 to 304 mm)), spec.,; Filament-wound plastic pipe; "fiberglass"pipe/pipe fittings (adhesivebonded joint type epoxy resin),; for condensate return lines (NPS 2 to 12 in. (50 to 304 mm)), spec.,; Joint strength; "fiberglass"pipe/pipe fittings (adhesive bonded jointtype epoxy resin),; for condensate return lines (NPS 2 to 12 in. (50 to 304 mm)), spec.,; Transfer molded pipe; "fiberglass"pipe/pipe fittings (adhesive bondedjoint type epoxy resin),; for condensate return lines (NPS 2 to 12 in. (50 to 304 mm)), spec; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

23.040.20 (Plastics pipes)

23.040.45 (Plastics fittings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.