ASTM-D573 Historical Revision Information
Standard Test Method for Rubber - Deterioration in an Air Oven

ASTM-D573 - 1988 EDITION - SUPERSEDED -- See the following: ASTM-D428
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Rubber—Deterioration in an Air Oven
ORDER

Scope

1.1 This test method describes a procedure to determine the influence of elevated temperature on the physical properties of vulcanized rubber. The results of this test method may not give an exact correlation with service performance since performance conditions vary widely. This test method may, however, be used to evaluate rubber compounds on a laboratory comparison basis.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific precautionary statement, see Note 1.)

Keywords

accelerated aging; elevated temperature; oxidative aging; rubber articles; rubber products; thermal aging; ICS Number Code 83.060 (Rubber)

To find similar documents by ASTM Volume:

09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)

To find similar documents by classification:

83.060 (Rubber Raw rubber, see 83.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D573-88

Revision Level

1988 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

April 29, 1988

Document Type

Test Method

Page Count

5 pages

Committee Number

D11.15