ASTM-D5766 Standard Test Method for Open-Hole Tensile Strength of Polymer Matrix Composite Laminates

ASTM-D5766 - 2023 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Open-Hole Tensile Strength of Polymer Matrix Composite Laminates
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This test method determines the open hole tensile strength of polymer matrix composite laminates reinforced by high-modulus fibers. The composite material forms are limited to continuous-fiber or discontinuous-fiber reinforced composites in which the laminate is balanced and symmetric with respect to the test direction. The standard test laminate is of the [45/0/-45/90] ns stacking sequence family, where the sublaminate repeat index is adjusted to yield a laminate thickness within the range discussed in 8.2.1. Other laminates may be tested provided the laminate configuration is reported with the results, however, the test method is unsatisfactory for unidirectional tape laminates containing only one ply orientation.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

Keywords

Tension (tensile) properties/tests; ICS Number Code 83.120 (Reinforced plastics)

To find similar documents by ASTM Volume:

15.03 (Space Simulation; Aerospace and Aircraft; Composite Materials)

To find similar documents by classification:

83.120 (Reinforced plastics Materials for the reinforcement of plastics, see 59.100)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

NAS-410
NAS Certification and Qualification of Nondestructive Test Personnel

ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

MIL-H-7199
Heat Treatment of Wrought Copper-Beryllium Alloys, Process for (Copper Alloys: Numbers C17000, C17200, C17300, C17500, and C17510) (Superseded by SAE-AMS-H-7199)

Document Number

ASTM-D5766_D5766M-23

Revision Level

2023 EDITION

Status

Current

Modification Type

New

Publication Date

Sept. 19, 2023

Document Type

Test Method

Page Count

6 pages

Committee Number

D30.05