ASTM-D5801 › Historical Revision Information
Standard Test Method for Toughness and Tenacity of Bituminous Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the procedure for measuring the toughness and tenacity of bituminous materials. Typically, the test method has been used to characterize elastomer modified asphalts, although values for toughness and tenacity may be obtained for any type of polymer-modified or non-modified asphalt.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values given in SI units are to be regarded as the standard. The values given in inch-pound units in parentheses are for informational purposes only.
Keywords
asphalt cement; polymer modified asphalt; tenacity; tensile testing; toughness; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products); 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5801-95(2001)
Revision Level
1995 R01 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 10, 1995
Document Type
Test Method
Page Count
4 pages
Committee Number
D04.44