ASTM-D5873 › Historical Revision Information
Standard Test Method for Determination of Rock Hardness by Rebound Hammer Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the testing apparatus, sampling, test specimen preparation, and testing procedures for determinng the rebound hardness number of rock material using a spring-driven steel hammer, or concrete test hammer.
1.2 This test method is best suited for rock material with uniaxial compressive strengths (see Test Method D2938) ranging between approximately 1 and 100 MPa.
1.3 The portable testing apparatus may be used in the laboratory or field to provide a means of rapid assessment of rock hardness or to serve as an indicator of rock hardness.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cores; hardness; rock mass; rocks; unconfined compressive test; ICS Number Code 13.080.20 (Physical properties of soil)
To find similar documents by ASTM Volume:
04.08 (Soil and Rock (I): D420 - D5876)
To find similar documents by classification:
13.080.20 (Physical properties of soils)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5873-00
Revision Level
2000 EDITION
Status
Superseded
Publication Date
June 10, 2000
Document Type
Test Method
Page Count
4 pages
Committee Number
D18.12