ASTM-D6117 › Historical Revision Information
Standard Test Methods for Mechanical Fasteners In Plastic Lumber and Shapes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the evaluation of fastener use with "as manufactured" plastic lumber and shapes through the use of two different testing procedures.
1.2 The test methods appear in the following order: Test Method A- Nail, Staple, or Screw Withdrawal Test; Test Method B- Lateral Nail, Staple, or Screw Resistance Test.
1.3 Plastic lumber and lastic shapes are currently made predominately from recycled plastics. However, this test method would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogenous in the cross-section.
1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1- There is no similar or equivalent ISO standard.
Keywords
mechanical fasteners; plastic lumber; plastic shapes; recycled plastics; ICS Number Code 83.140.01 (Rubber and plastic products in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
83.140.01 (Rubber and plastics products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6117-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
New
Publication Date
April 10, 1997
Document Type
Test Method
Page Count
7 pages
Committee Number
D20.20