ASTM-D6279 Historical Revision Information
Standard Test Method for Rub Abrasion Mar Resistance of High Gloss Coatings

ASTM-D6279 - 2003 R07 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Rub Abrasion Mar Resistance of High Gloss Coatings
ORDER

Scope

1.1 This test method covers procedures for evaluating the relative mar resistance of a series of high gloss coatings applied to a flat, rigid surface. Wet rub and dry rub abrasion tests are described. To fully characterize a coating's mar resistance, both tests should be run.

Note 1 - Dry abrasion mar resistance can also be evaluated by using Test Methods D 6037. If a series of very highly mar resistant coatings is being evaluated, Test Methods D 6037 will generally provide the better performance discrimination than the dry rub test described here. However, if the equipment described in Test Methods D 6037 is not available, the dry rub test described in this test method affords a reasonable alternative. The dry rub test is also useful for evaluating coatings that are not highly mar resistant.

1.2 Mar resistance is assessed by measuring the gloss of the abraded and unabraded areas. Mar resistance is directly related to the coating's ability to retain gloss in abraded areas.

Note 2 - The mar resistance values obtained by this test method have no absolute significance. They should only be used to derive relative performance rankings for test panels that have been prepared from the series of coatings that are currently being evaluated. If mar resistance values are quoted between laboratories, it is essential that a common standard be measured and that the values be compared to that standard. Even then, the values should be used with caution.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Coatings, particularly the high gloss coatings used on automobiles, boats, toys, etc., are subject of a wide variety of conditions (for example, wiping, cleaning and exposure) during manufacture and service that can mar their surface. The ability of high gloss coatings to maintain their appearance is an important product attribute. This test method provides a way to estimate the ability of high gloss coatings to resist mar damage.

Keywords

abrasion; aluminum; coatings; gloss; grit; mar; powder; rub test; scratch; ICS Number Code 25.220.99 (Other treatments and coatings)

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

25.220.99 (Other treatments and coatings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6279-03(2007)

Revision Level

2003 R07 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

July 1, 2007

Document Type

Test Method

Page Count

3 pages

Committee Number

D01.55