ASTM-D6353 Standard Guide for Sampling Plan and Core Sampling for Prebaked Anodes Used in Aluminum Production

ASTM-D6353 - 2023 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Guide for Sampling Plan and Core Sampling for Prebaked Anodes Used in Aluminum Production
ORDER

Price:

$55.00        


Want this as a site license?

Scope

1.1 This guide covers sampling for prebaked carbon anodes used in the production of aluminum, and details procedures for taking test samples from anode blocks. It covers equipment and procedures for obtaining samples from anode blocks in a manner that does not destroy the block or prevent its subsequent use as originally intended. However, the user must determine the subsequent use of the sampled anode blocks. Preferred locations for taking samples from single units of anodes are covered in this guide.

1.1.1 Information for sampling of shaped refractory products, in general, is given in ISO 5022. This standard details the statistical basis for sampling plans for acceptance testing of a consignment or lot. Anodes used in the production of aluminum have specific requirements for sampling and while the statistical basis for sampling given in ISO 5022 applies, further or modified requirements may also apply.

1.1.2 Information for sampling of anodes for Al-metal production is given in ISO 8007-2. This standard details the statistical basis for sampling plans for acceptance testing of a consignment or lot.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: The following ASTM standards are noted as sources of useful information: Test Methods D5502, D6120, D6744, and D6745.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

4.1 Core sampling is an acceptable way of obtaining a test specimen without destroying the usefulness of an anode block.

4.1.1 Test specimen obtained by this guide can be used by producers and users of carbon anodes for the purpose of conducting the tests in Note 1 to obtain comparative physical properties.

4.2 Sampling shall not weaken the anode or increase the likelihood of premature failure.

Keywords

anode; anthracite; carbon; core; graphite; prebaked; sample; sampling; test specimens;

To find similar documents by ASTM Volume:

05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)

05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)

To find similar documents by classification:

77.020 (Production of metals)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6353-23

Revision Level

2023 EDITION

Status

Current

Modification Type

Revision

Publication Date

July 25, 2023

Document Type

Guide

Page Count

4 pages

Committee Number

D02.05