ASTM-D6470 › Standard Test Method for Salt in Crude Oils (Potentiometric Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of salt in crude oils. For the purpose of this test method, salt is expressed as % (m/m) NaCl (sodium chloride) and covers the range from 0.0005 to 0.15 % (m/m).
1.2 The limit detection is 0.0002 % (m/m) for salt (as NaCl).
1.3 The test method is applicable to nearly all of the heavier petroleum products, such as crude oils, residues, and fuel oils. It may also be applied to used turbine oil and marine diesel fuel to estimate seawater contamination. Water extractable salts, originating from additives present in oils, are codetermined.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
crude oil; extraction; potentiometric; salt; ICS Number Code 75.180.30 (Volumetric equipment and measurements)
To find similar documents by ASTM Volume:
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)
To find similar documents by classification:
75.180.30 (Volumetric equipment and measurements)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6470-99R20
Revision Level
1999 R20 EDITION
Status
Current
Modification Type
New
Publication Date
June 11, 2020
Document Type
Test Method
Page Count
6 pages
Committee Number
D02.03