ASTM-D6478 Historical Revision Information
Standard Test Method for Determining Specific Packability of Fabrics Used in Inflatable Restraints

ASTM-D6478 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determining Specific Packability of Fabrics Used in Inflatable Restraints
ORDER

Scope

1.1 This test method covers procedures for determining the ability to fold and pack fabrics used for inflatable restraints using an index of specific packability.

1.2 Procedures in this test method describe operator techniques that must be followed closely to obtain repeatable and accurate results. Since these techniques are difficult to convey in writing, supplemental training for operators is required. A training video is available from ASTM (see Adjuncts ADJD6478 and ADJD6478A and ).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

1.4 Procedures and apparatus other than those stated in this practice may be used as agreed upon between the purchaser and the supplier with specific deviations from this practice acknowledged in the report.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is useful for determining the specific packability of uncoated and coated airbag fabrics. Fabric packability is an important factor in the design of airbag modules due to their inherent spacial contraints.

A folded specimen exhibits better specific packability if it occupies a lower total volume at the specified loads compared to another specimen.

The time required to test one sample (four specimens from the same lot of fabric) is approximately 1.5 h using this test method. Due to the length of time required by this test method to perform a single test, this test method is most suitable for use in design and development analysis or for inclusion in a list of required tests conducted for annual certification of an airbag fabric.

Keywords

airbag; fabric; inflatable restraint; packability; packing; volume; Airbag materials/applications; Inflatable restraints; Packing/packaging materials/systems; Specific packability; Textile fabrics (general); Volumetric measurement; ICS Number Code 43.040.60 (Bodies and body components); 59.080.30 (Textile fabrics)

To find similar documents by ASTM Volume:

07.02 (Textiles (II): D4393 - latest)

To find similar documents by classification:

43.040.60 (Bodies and body components Including vehicle frame and structure, heating devices, air-conditioning systems for passenger/driver compartments, roof load carriers, etc. Loading compartments, see 43.080.10)

59.080.30 (Textile fabrics Including nonwovens, felts, lace, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D6478-08

Revision Level

2008 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

July 1, 2008

Document Type

Test Method

Page Count

5 pages

Committee Number

D13.20