Document Center is acquired by Nimonik

Scope

1.1 This test method covers a procedure to determine the recovery response of rubber after particular bending deformation, subsequent to aging in selected media at a specified temperature, and for a specified time period, thus providing a measure of the relative performance potential of compounds used in the manufacture of shaft seals.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

recovery from bending; rubber; shaft seals; ICS Number Code 83.140.50 (Seals)

To find similar documents by ASTM Volume:

09.02 (Rubber Products, Industrial - Specifications and Related Test Methods; Gaskets; Tires)

To find similar documents by classification:

83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.