ASTM-D6737 › Standard Test Method for Bulk Density of Tapered Paintbrush Filaments
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a procedure for measuring the weight of filaments per unit volume.
1.2 This method is applicable only to monofilament with tapered longitudinal profiles.
1.3 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
3.1 Filaments are available in a variety of cross-sections and materials. A measure of bulk density permits the brushmaker to estimate the weight of filament required to prepare a given number of brushes.
Keywords
bulk density; density; filaments; paint brush;; ICS Number Code 87.100 (Paint coating equipment)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.100 (Paint coating equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6737-12(2017)
Revision Level
2012 R17 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 15, 2017
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.61