ASTM-D6769 › Standard Guide for Application of Fully Adhered, Cold-Applied, Prefabricated Reinforced Modified Bituminous Membrane Waterproofing Systems
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide lists application and installation requirements for fully adhered, cold-applied, prefabricated modified bituminous membrane waterproofing systems for below-grade or below-wearing-surface (such as plaza decks) vertical or horizontal applications.
1.2 For the purposes of this application guide, the substrate is assumed to be structurally sound, sloped to drain (if new construction), and meeting the local building code requirements. Similarly, the system components are assumed to comply with all federal, state, and local requirements in effect at the time of installation.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This guide may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 This guide outlines general procedures for the storage and application of various prefabricated sheets made using modified bituminous materials and intended for use as below-grade and below-wearing-surface waterproofing.
4.2 The substrate used for applications described in this guide shall be concrete or masonry.
4.3 This application consists of a prefabricated reinforced modified bituminous sheet applied to a suitable substrate using a bituminous-based, cold-applied adhesive or mastic. Application rates given are typical for such installations.
4.4 This guide is intended to supplement instructions from designers and manufacturers.
Keywords
adhesive; cold applied; modified bituminous; prefabricated; reinforced; waterproofing;; ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6769/D6769M-02(2018)
Revision Level
2002 R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Oct. 15, 2018
Document Type
Guide
Page Count
3 pages
Committee Number
D08.22