ASTM-D6900 › Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This method covers a procedure for measuring by scrubbing the adhesion of latex paints to glossy alkyd enamel substrates after exposure to wet conditions.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
After application to either interior or exterior surfaces, latex paints may be subjected to conditions of high humidity, condensation, or precipitation. This may sometimes lead to a loss of adhesion to the substrate over which they have been applied. This method is a quantitative measure of the adhesion of latex paints to glossy substrates under such conditions.
Keywords
wet adhesion; ICS Number Code 87.040 (Paints and varnishes)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6900-10R20
Revision Level
2010 R20 EDITION
Status
Current
Modification Type
New
Publication Date
Dec. 15, 2020
Document Type
Test Method
Committee Number
D01.42