ASTM-D7004 › Standard Test Method for Grab Tensile Properties of Reinforced Geomembranes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is used to measure the grab tensile properties of reinforced geomembranes.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This method evaluates grab tensile properties of reinforced geomembranes for the purposes of quality control, quality assurance and research. In order to evaluate the full contribution of the reinforcement, testing is performed parallel to the directions of reinforcement. This method is an index test and is not intended for design purposes.
Keywords
geomembrane; grab tensile; reinforced; tensile; ICS Number Code 59.080.70 (Geotextiles)
To find similar documents by ASTM Volume:
To find similar documents by classification:
59.080.70 (Geotextiles Including geosynthetics)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7004_D7004M-03R21
Revision Level
2003 R21 EDITION
Status
Current
Modification Type
New
Publication Date
July 8, 2021
Document Type
Test Method
Page Count
2 pages
Committee Number
D35.10