ASTM-D7024 Standard Test Method for Steady State and Dynamic Thermal Performance of Textile Materials (Withdrawn 2013)

ASTM-D7024 - 2004 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Steady State and Dynamic Thermal Performance of Textile Materials (Withdrawn 2013)
ORDER

Scope

1.1 This test method covers the determination of the overall thermal transmission coefficient due to conduction for dry specimens of textile fabrics, battings, and other materials and the determination of the temperature regulating factor (TRF) defined below.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This method provides for the determination of the steady state thermal resistance of a fabric or layers of fabrics and for the determination of the temperature regulating factor (TRF) as defined below. This test method is considered satisfactory for acceptance testing of commercial shipments because the round robin testing shows high precision and no bias for testing of textile fabrics and foams.

5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.

This test method is useful in quality and cost control during manufacture. It can be used to establish criteria for establishing thermal and comfort parameters for textiles particularly used in the clothing industry.

Keywords

ICS Number Code 59.080.01 (Textiles in general)

To find similar documents by ASTM Volume:

07.02 (Textiles (II): D4393 - latest)

To find similar documents by classification:

59.080.01 (Textiles in general Including colour fastness of textiles)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D7024-04

Revision Level

2004 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

March 1, 2004

Document Type

Test Method

Page Count

4 pages

Committee Number

D13.51