ASTM-D7073 › Standard Guide for Application and Evaluation of Brush and Roller Applied Paint Films
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide describes procedures for the application of brush or roller, or both, applied paint films to sealed wallboard for evaluating application properties.
1.2 Because both the application and panel evaluation are subjective, this guide should be used only for comparative testing within one laboratory using one operator for each set of applications, as the ratings assigned by different laboratories may not agree.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 Laboratory measurement of application properties of architectural coatings generally employ a blade-type applicators that lay down films of highly uniform thickness. Applicators, such as brushes and rollers, typically apply films that lack uniformity due to variations in rheology, film build, flow and leveling properties resulting in the practical hiding of most paints being less than that measured on films applied with a blade-type applicator. This guide provides an indication of the actual application properties of the paint, as applied by a contractor or consumer.
Keywords
application; paint brush films; paint roller films;
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.020 (Paint coating processes Surface preparation for painting, see 25.220.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7073-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 14, 2020
Document Type
Guide
Page Count
4 pages
Committee Number
D01.42