ASTM-D7088 › Standard Practice for Resistance to Hydrostatic Pressure for Coatings Used in Below Grade Applications Applied to Masonry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice is for the evaluation of coatings used in below grade applications to resist the passage of water through concrete block.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 This test is meant to simulate the ability of a coating applied to a basement or other below grade masonry walls to prevent the intrusion of water through the coating caused by hydrostatic pressure from water on the outside of the structure.
Keywords
coatings-masonry; resistance to hydrostatic pressure;; ICS Number Code 91.080.40 (Concrete structures)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7088-17
Revision Level
2017 EDITION
Status
Current
Modification Type
Reinstated
Publication Date
Aug. 1, 2017
Document Type
Practice
Page Count
3 pages
Committee Number
D01.47