ASTM-D7209 Standard Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products (Withdrawn 2015)

Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products (Withdrawn 2015)


1.1 This guide provides information for the development of standards (guides, practices, terminology, test methods, or specifications) relating to plastics recycling and other means of waste reductions and resource recovery.

1.2 This guide is directed to consumer, commercial, and industrial sources of thermoplastics and thermoset polymeric materials.

1.3 This guide addresses terminology, performance standards, specifications, quality assurance, separation or segregation of product by classes, identification and marking of generic classes, contaminants, fillers, designing for recycle, degradable products, reconstituted products, biobased resins, certification and percentages of recycled products, and other methods of waste reduction and resource recovery.

1.4 This guide does not address parameters or factors involving the original manufacture of virgin polymers or the fabrication of consumer products from these virgin polymers.

1.5 This guide is intended to replace Guide D 5033.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

There is no equivalent ISO standard. ISO/DIS 15270 is similar in scope and content.

Significance and Use

This guide is intended for use by committees or agencies concerned with the development of standards related to recycling, waste reduction, and resource recovery. Such standards are expected to provide uniform, standardized approaches by specifiers, codes, authorities having jurisdiction (AHJs), and consumers.

It is anticipated that more specific guides or standards are being or will be developed to address specific requirements.


plastics recycling; polymeric material; reconstituted plastics; resource recovery; waste reduction; ICS Number Code 13.020.99 (Other standards related to environmental protection); 13.030.50 (Recycling)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

13.020.99 (Other standards related to environmental protection)

13.030.50 (Recycling Including relevant equipment Motor vehicle recycling, see 43.020)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number


Revision Level




Modification Type


Publication Date

Jan. 15, 2006

Document Type


Page Count

6 pages

Committee Number