ASTM-D732 Historical Revision Information
Standard Test Method for Shear Strength of Plastics by Punch Tool

ASTM-D732 - DOD ADOPTION 1 - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Shear Strength of Plastics by Punch Tool
ORDER

Scope

1.1 This test method covers the punch-type of shear test and is intended for use in determining the shear strength of test specimens of organic plastics in the form of sheets and molded disks in thicknesses from 0.127 to 12.7 mm (0.050 to 0.500 in.).

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

Keywords

punch tool; shear strength; ICS Number Code 83.080.01 (Plastics in general)

To find similar documents by ASTM Volume:

08.01 (Plastics (I): D256 - D3159)

To find similar documents by classification:

83.080.01 (Plastics in general)

To find similar documents by Federal Supply Class Code:

FSC 9330 (Plastics Fabricated Materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D732

Revision Level

DOD ADOPTION 1

Status

Superseded

Modification Type

Revision

Publication Date

April 9, 1991

Document Type

Test Method

Page Count

1 page

Committee Number

D20.10