ASTM-D7328 › Historical Revision Information
Standard Test Method for Determination of Existent and Potential Inorganic Sulfate and Total Inorganic Chloride in Fuel Ethanol by Ion Chromatography Using Aqueous Sample Injection
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers an ion chromatographic procedure for the determination of the existent inorganic and potential sulfate and total inorganic chloride content in hydrous and anhydrous denatured ethanol to be used in motor fuel applications. It is intended for the analysis of ethanol samples containing between 0.55 and 20 mg/kg of existent inorganic sulfate, 4.0 to 20 mg/kg of potential inorganic sulfate, and 0.75 to 50 mg/kg of total inorganic chloride.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.
Significance and Use
Sulfates and chlorides may be found in filter plugging deposits and fuel injector deposits. The acceptability for use of the fuel components and the finished fuels depends on the sulfate and chloride content.
Existent and potential inorganic sulfate and total chloride content, as measured by this test method, can be used as one measure of the acceptability of gasoline components for automotive spark-ignition engine fuel use.
Keywords
aqueous injection; denatured ethanol; ethanol; existent inorganic sulfate; fuel ethanol; ion chromatography; potential sulfate; total chloride: Aqueous samples; Denatured fuel ethanol; Fuel ethanol (Ed75-Ed85); Inorganic sulfate; Ion chromatography (IC); Total chloride; ICS Number Code 75.160.20 (Liquid fuels)
To find similar documents by ASTM Volume:
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)
To find similar documents by classification:
75.160.20 (Liquid fuels Including gasoline, diesel, kerosene, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7328-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Aug. 1, 2011
Document Type
Test Method
Page Count
8 pages
Committee Number
D02.03