ASTM-D7462 Standard Test Method for Oxidation Stability of Biodiesel (B100) and Blends of Biodiesel with Middle Distillate Petroleum Fuel (Accelerated Method) (Withdrawn 2016)

ASTM-D7462 - 2011 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Oxidation Stability of Biodiesel (B100) and Blends of Biodiesel with Middle Distillate Petroleum Fuel (Accelerated Method) (Withdrawn 2016)
ORDER

Scope

1.1 This test method covers a measurement of the oxidation stability of biodiesel (B100) blendstock as specified in Specification D6751 and blends of biodiesel with middle distillate petroleum fuels, including B6 to B20 blends as specified in Specification D7467 under specified oxidizing conditions at 95°C. Specifically, the oxidation stability is assessed by the formation and measurement of insoluble degradation materials.

Note 1—Biodiesel B100, composed of alkyl esters, can have good solubility for some products of oxidative degradation. Thus some B100 samples could undergo significant degradation, but show little or no sediment formation. By contrast, many petroleum diesel fuels have relatively poor solubility for products of oxidative degradation, so Bxx blends, such as B20, could show higher sediment levels. Refer to Appendix X1 for a suggested paraffinic dilution procedure to evaluate oxidative degradation of B100 for degradation materials that are soluble in B100, but insoluble in iso-octane.

Note 2—No. 1 and No. 2 grades in Specifications D396 or D975 currently allow up to 5% biodiesel meeting Specification D6751. This method is preferred for testing these fuels that may contain biodiesel blendstock rather than Test Method D2274 due to the incompatibility of biodiesel blendstock with the membrane filters specified in Test Method D2274.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

adherent insolubles; biodiesel fuel; filterable insolubles; oxidation stability; Biodiesel; Biodiesel fuel (B100) blend stock; Middle distillate fuels; Oxidation stability; ICS Number Code 75.160.20 (Liquid fuels)

To find similar documents by ASTM Volume:

05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)

To find similar documents by classification:

75.160.20 (Liquid fuels Including gasoline, diesel, kerosene, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D7462-11

Revision Level

2011 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Jan. 1, 2011

Document Type

Test Method

Page Count

6 pages

Committee Number

D02.14