ASTM-D7834 › Standard Test Method for Filling Material Shedding of Paint Brushes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the procedure for testing the shedding properties of both natural bristle and synthetic filament paint brushes (referred as filling material).
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.
Significance and Use
3.1 During the application of coatings, paint brushes can exhibit shedding of filling material onto the coated surface. A measure of this shedding filling material will determine the paint brush’s ability to resist shedding during application.
Keywords
brush ferrule; brush filling material; length clear; ICS Number Code 87.100 (Paint coating equipment)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.100 (Paint coating equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7834-13R19
Revision Level
2013 R19 EDITION
Status
Current
Modification Type
New
Publication Date
Oct. 1, 2019
Document Type
Test Method
Page Count
2 pages
Committee Number
D01.61