ASTM-D7934 Standard Test Method for Corrosion of Cast Aluminum Alloys in Non-Aqueous Engine Coolants Under Heat-Rejecting Conditions (Withdrawn 2023)

ASTM-D7934 - 2014 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Corrosion of Cast Aluminum Alloys in Non-Aqueous Engine Coolants Under Heat-Rejecting Conditions (Withdrawn 2023)

Scope

1.1 This test method covers a laboratory screening procedure for evaluating the effectiveness of non-aqueous engine coolants in combating corrosion of aluminum casting alloys under heat-transfer conditions that may be present in aluminum cylinder head engines.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Some values have only SI units because the inch-pound equivalents are not used in practice.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Sections 11 and 12.

Significance and Use

4.1 It is essential that engine coolants prevent heat-transfer corrosion of aluminum cylinder heads during engine operation. Any corrosion products formed may deposit on interior radiator surfaces, reducing heat-transfer efficiency of the radiator. Overheating and boil-over of the cooling system may then occur.

4.2 This test method provides a means for selectively screening unused non-aqueous engine coolants and will readily distinguish those coolants that are unsuitable for use with aluminum cylinder head engines. However, satisfactory performance of a coolant in this test method does not ensure adequate long-term service performance. Additional, more comprehensive evaluations with simulated service, dynamometer, and vehicle tests should be used to establish the long-term effectiveness of the coolant.

Keywords

aluminum; anhydrous; cast aluminum alloys; corrosion; cylinder head; engine coolant; heat transfer; non-aqueous

To find similar documents by ASTM Volume:

15.05 (Engine Coolants; Halogenated Organic Solvents and Fire Extinguishing Agents; Industrial and Specialty Chemicals)

To find similar documents by classification:

71.100.45 (Refrigerants and antifreezes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D7934/D7934M-14

Revision Level

2014 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Sept. 1, 2014

Document Type

Test Method

Page Count

4 pages

Committee Number

D15.22