ASTM-D8030 Standard Practice for Sample Preparation for GCCM

ASTM-D8030 - 2023 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Sample Preparation for GCCM
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This standard practice specifies a set of instructions for preparing samples of geosynthetic cementitious composite mat (GCCM) for index property testing.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.3.1 For purposes of comparing measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits.

1.3.2 The procedures used to specify how data are collected/recorded or calculated in this practice are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be measured. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the users objectives; and it is common practice to increase or reduce the significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this practice to consider significant digits used in the analytical methods for engineering design.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Some specific hazards statements are given in Section 7 on Hazards.

Significance and Use

5.1 This practice is intended to create specimens of GCCM products appropriate for testing for the determination of index properties. Cured (hardened) samples are not necessarily intended to represent a field application of GCCM products but would be representative of the correct amount of water applied to a known style of product and provide a basis for consistent and repeatable index property testing.

Keywords

GCCM; geosynthetic cementitious composite mat; index test; preparation; sampling;; ICS Number Code 59.080.70 (Geotextiles); 91.100.99 (Other construction materials)

To find similar documents by ASTM Volume:

04.13 (Geosynthetics)

To find similar documents by classification:

59.080.70 (Geotextiles Including geosynthetics)

91.100.99 (Other construction materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D8030_D8030M-23

Revision Level

2023 EDITION

Status

Current

Modification Type

New

Publication Date

March 1, 2023

Document Type

Practice

Page Count

5 pages

Committee Number

D35.05