ASTM-D8213 › Standard Test Method for Determination of Boron in Coal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes a procedure for the analysis of total boron in coal.
1.2 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 The possible emission of boron that may be found in coal from coal combustion is an environmental concern.
5.2 When test portions are burned according to this procedure, the total boron is quantitatively retained and is representative of concentrations in the whole coal.
Keywords
boron; coal; inductively coupled plasma mass spectrometer; trace elements;; ICS Number Code 75.160.10 (Solid fuels)
To find similar documents by ASTM Volume:
05.06 (Gaseous Fuels; Coal and Coke)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D8213-18
Revision Level
2018 EDITION
Status
Current
Modification Type
New
Publication Date
Dec. 1, 2018
Document Type
Test Method
Page Count
7 pages
Committee Number
D05.29