ASTM-D991 › Historical Revision Information
Standard Test Method for Rubber Property - Volume Resistivity Of Electrically Conductive and Antistatic Products
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of volume resistivity of rubbers used in electrically conductive and antistatic products.
1.2 This test method assumes that the surface conductivity is negligible compared with the conductivity through the specimen.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 The electrical behavior of rubber products used in particular applications is important for a variety of reasons such as safety, static changes, current transmission, etc. This test method is useful in predicting the behavior of such rubber products.
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D991-89(2014)
Revision Level
1989 R14 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 15, 2014
Document Type
Test Method
Page Count
5 pages
Committee Number
D11.10