ASTM-E102 › Standard Test Method for Saybolt Furol Viscosity of Bituminous Materials at High Temperatures
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the empirical procedures for determining the Saybolt Furol viscosities of bituminous materials at specified temperatures between 248 and 464°F (120 and 240°C).
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 8.1.
Keywords
Bituminous roofing membranes; Viscometers-Saybolt-Furol; Viscosity-asphalts/bituminous materials; Saybolt Furol viscosity of bituminous materials at high temperatures,; test; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E0102_E0102M-93R21
Revision Level
1993 R21 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 11, 2021
Document Type
Test Method
Page Count
3 pages
Committee Number
D08.05