ASTM-E1086 Historical Revision Information
Standard Test Method for Analysis of Austenitic Stainless Steel by Spark Atomic Emission Spectrometry

ASTM-E1086 - 1994 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Analysis of Austenitic Stainless Steel by Spark Atomic Emission Spectrometry
ORDER

Scope

1.1 This test method provides for the optical emission vacuum spectrometric analysis of stainless steel in solid form by the point-to-plane excitation technique for the following elements in the concentration ranges shown:

ElementConcentration Range, %
Chromium17.0 to 23.0
Nickel 7.5 to 13.0
Molybdenum0.01 to 3.0
Manganese0.01 to 2.0
Silicon 0.01 to 0.90
Copper 0.01 to 0.30
Carbon 0.005 to 0.25
Phosphorus0.003 to 0.15
Sulfur 0.003 to 0.065

1.2 This test method is designed for the routine analysis of chill-cast disks or inspection testing of stainless steel samples that have a flat surface of at least 13 mm (0.5 in.) in diameter. The samples must be sufficiently massive to prevent overheating during the discharge and of a similar metallurgical condition and composition as the reference materials.

1.3 Analytical curves are plotted using the concentration ratio method as shown in Practice E158. One or more of the reference materials must closely approximate the composition of the specimen. The technique of analyzing reference materials along with unknowns and performing the indicated mathematical corrections may also be used to correct for interference effects and to compensate for errors resulting from instrument drift. A variety of such systems are commonly used. Any of these that will achieve analytical accuracy equivalent to that reported for this test method are acceptable.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

optical emission; point-to-plane technique; spectrometric analysis; stainless steel; ICS Number Code 77.040.30 (Chemical analysis of metals); 77.140.20 (Steels of high quality)

To find similar documents by ASTM Volume:

03.05 (Analytical Chemistry for Metals, Ores, and Related Materials: E 32 - latest)

To find similar documents by classification:

77.040.30 (Chemical analysis of metals Chemical analysis in general, see 71.040.40 Chemical analysis of ferrous metals, see 77.080 Chemical analysis of ferroalloys, see 77.100 Chemical analysis of non-ferrous metals, see 77.120 Chemical analysis of sintered metals and hard metals, see 77.160)

77.140.20 (Stainless steels Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E1086-94

Revision Level

1994 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Jan. 15, 1994

Document Type

Test Method

Page Count

5 pages

Committee Number

E01.01