ASTM-E1275 › Standard Practice for Use of a Radiochromic Film Dosimetry System (Withdrawn 2002)
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This practice covers the handling, testing, and procedure for using a radiochromic film dosimetry system to measure absorbed dose in materials irradiated by photons or electrons in terms of absorbed dose in water.
1.2 This practice applies to radiochromic film dosimeters that can be used within part or all of the specified ranges as follows:
1.2.1 The absorbed dose range is 1 X 10-2 to 1
1.2.2 The absorbed dose rate is 1 X 10-2 to 1
1.2.3 The radiation energy range for both photons and electrons is 0.1 to 50 MeV.
1.2.4 The irradiation temperature range is -78 to +60°C.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Calibration-nuclear analysis instrumentation; Destructive testing-irradiation; Dosimetry; Electron radiation; Energy deposition-ionizing radiation; Ionizing radiation; Irradiance/irradiation; Photometry; Radiation exposure-nuclear materials/applications; Radiochromic dosimetry system; Spectrophotometry; radiochromic film dosimetry systems, test; ICS Number Code 17.240 (Radiation measurements)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
June 1, 1999