ASTM-E1575 Historical Revision Information
Standard Practice for Pressure Water Cleaning and Cutting

ASTM-E1575 - 1993 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Pressure Water Cleaning and Cutting
ORDER

Scope

1.1 This practice covers the personnel requirements, operator training, operating procedures, and recommended equipment performance/design for the proper operation of all types of pressure water-jet cleaning and cutting equipment as normally used by industries concerned with construction, maintenance, repair, cleaning, cutting, and demolition work.

1.2 The term high-pressure water jetting covers all water jetting, including the use of additives or abrasives at pressures above 1005 psig (6.9 MPa).

1.3 Any person required to operate or maintain pressure water-jetting equipment shall have been trained and have demonstrated the ability and knowledge to do so in accordance with the original equipment manufacturer's instructions, specifications, and training programs.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Notes 1 through 8 and Section 8 for specific hazards statements.

Keywords

abrasive blasting; cleaning; construction; cutting; demolition; hydrojetting; lancing; moleing; shotgunning; water blasting; ICS Number Code 25.100.01 (Cutting tools in general); 25.220.20 (Surface treatment)

To find similar documents by ASTM Volume:

11.03 (Occupational Health and Safety; Protective Clothing)

To find similar documents by classification:

25.100.01 (Cutting tools in general)

25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E1575-93

Revision Level

1993 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

Oct. 15, 1993

Document Type

Practice

Page Count

9 pages

Committee Number

E34.03