ASTM-E1813 › Historical Revision Information
Standard Practice for Measuring and Reporting Probe Tip Shape in Scanning Probe Microscopy
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers scanning probe microscopy and describes the parameters needed for probe shape and orientation.
1.2 This practice also describes a method for measuring the shape and size of a probe tip to be used in scanning probe microscopy. The method employs special sample shapes, known as probe characterizers, which can be scanned with a probe microscope to determine the dimensions of the probe. Mathematical techniques to extract the probe shape from the scans of the characterizers have been published (2-5).
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
microscopy; probe; scanning
To find similar documents by ASTM Volume:
03.06 (Molecular Spectroscopy; Surface Analysis)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1813-96e1
Revision Level
1996(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 10, 1996
Document Type
Practice
Page Count
11 pages
Committee Number
E42.14