ASTM-E190 › Standard Test Method for Guided Bend Test for Ductility of Welds
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a guided bend test for the determination of soundness and ductility of welds in ferrous and nonferrous products. Defects, not shown by X rays, may appear in the surface of a specimen when it is subjected to progressive localized overstressing. This guided bend test has been developed primarily for plates and is not intended to be substituted for other methods of bend testing.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are in parentheses and may be approximate.
Note-For additional information see Terminology E6, and American Welding Society Standard D1.1.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .
Keywords
Bend testing-metallic materials; ICS Number Code 25.160.40 (Welding joints and welds)
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-E18Standard Test Methods for Rockwell Hardness of Metallic Materials
ASTM-A240
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
QPL-AMS-2644
Inspection Material, Penetrant
Document Number
ASTM-E0190-21
Revision Level
2021 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Aug. 27, 2021
Document Type
Test Method
Page Count
4 pages
Committee Number
E28.02