ASTM-E2008 › Standard Test Methods for Volatility Rate by Thermogravimetry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for assessing the volatility of solids and liquids at given temperatures using thermogravimetry under prescribed experimental conditions. Results of this test method are obtained as volatility rates expressed as mass per unit time. Rates > or = to 5 µg/min are achievable with this test method.
1.2 Temperatures typical for this test method are within the range from 25 °C to 500°C. This temperature range may differ depending upon the instrumentation used.
1.3 This test method is intended to provide a value for the volatility rate of a sample using a thermogravimetric analysis measurement on a single representative specimen. It is the responsibility of the user of this test method to determine the need for and the number of repetitive measurements on fresh specimens necessary to satisfy end use requirements.
1.4 Computer- or electronic-based instruments, techniques, or data treatment equivalent to this test method may also be used.
Note 1-Users of this test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user of this test method to determine the necessary equivalency prior to use.
1.5 The values stated in SI units are to be regarded as the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
mass loss; thermogravimetric analysis (TGA); thermogravimetry (TG); volatility; volatility rate; ICS Number Code 71.040.50 (Physicochemical methods of analysis)
To find similar documents by ASTM Volume:
To find similar documents by classification:
19.020 (Test conditions and procedures in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E2008-17R21
Revision Level
2017 R21 EDITION
Status
Current
Modification Type
New
Publication Date
July 14, 2021
Document Type
Test Method
Page Count
6 pages
Committee Number
E37.01