Document Center is acquired by Nimonik

Scope

1.1 This practice describes the sampling of copper (except electrolytic cathode) and copper alloys in either cast or wrought form for the determination of composition.

1.2 Cast products may be in the form of cake, billet, wire bar, ingot, ingot bar, or casting.

1.3 Wrought products may be in the form of flat, pipe, tube, rod, bar, shape, or forging.

1.4 This practice is not intended to supersede or replace existing specification requirements for the sampling of a particular material.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement appears in Appendix X4.

Keywords

Copper-chemical analysis; Copper alloys-chemical analysis; Sampling-nonferrous metals/alloys; sampling copper/alloys for chemical composition, practice

To find similar documents by ASTM Volume:

03.05 (Analytical Chemistry for Metals, Ores, and Related Materials: E 32 - latest)

To find similar documents by classification:

77.040.30 (Chemical analysis of metals Chemical analysis in general, see 71.040.40 Chemical analysis of ferrous metals, see 77.080 Chemical analysis of ferroalloys, see 77.100 Chemical analysis of non-ferrous metals, see 77.120 Chemical analysis of sintered metals and hard metals, see 77.160)

77.120.30 (Copper and copper alloys)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.