ASTM-E32 Standard Practices for Sampling Ferroalloys and Steel Additives for Determination of Chemical Composition

ASTM-E32 - 2021 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practices for Sampling Ferroalloys and Steel Additives for Determination of Chemical Composition
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 These practices include procedures for the sampling of the various ferroalloys and steel additives, either before or after shipment from the plants of the manufacturers. They are designed to give results representative of each lot that will be comparable with the manufacturer's guaranteed analysis for the same lot. For check analysis, the purchaser may use any sampling procedure he desires, but the analytical results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these methods.

1.2 In sampling ferroalloys and steel additives, serious errors often occur from contamination of the samples by iron from the sampling appliances. Therefore, special precautions should be observed to avoid this source of error. Metallic iron may be removed with a magnet from nonmagnetic alloys; its estimation in other alloys requires special analytical procedures (Note 1). To avoid this error, parts of crushers and pulverizing equipment contacting the samples shall be of steel or other material showing a high resistance to abrasion of the type involved. Note 0Metallic iron in ferrochromium and ferrosilicon may be determined as follows: Transfer 5 g of the sample of alloy to a 150-mL beaker, add 25 mL of HNO3 (1 + 3), cover, boil 5 min, filter into a 250-mL beaker, and wash with hot water. Add NH4OH in slight excess, heat to boiling, filter, and wash with hot water. Dissolve the precipitate on the paper with a minimum quantity of hot HCl (1 + 2), wash the filter with hot water, and titrate the iron by a standard procedure such as that described in Methods E38.

1.3 The values stated in SI units are to be regarded as the standard. The inch-pound values in parenthesis are given for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

chemical composition; ferroalloys; sampling; steel additives; ICS Number Code 77.040.30 (Chemical analysis of metals); 77.100 (Ferroalloys)

To find similar documents by ASTM Volume:

03.05 (Analytical Chemistry for Metals, Ores, and Related Materials: E 32 - latest)

To find similar documents by classification:

77.040.30 (Chemical analysis of metals Chemical analysis in general, see 71.040.40 Chemical analysis of ferrous metals, see 77.080 Chemical analysis of ferroalloys, see 77.100 Chemical analysis of non-ferrous metals, see 77.120 Chemical analysis of sintered metals and hard metals, see 77.160)

77.100 (Ferroalloys Including classification, designation, sampling, chemical analysis, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASME-HST-5
Performance Standard for Air Chain Hoists

MIL-C-26482
Connectors, Electrical, (Circular, Miniature, Quick Disconnect, Environment Resisting)

CGA-C7
Guide to Classification and Labeling of Compressed Gases

Document Number

ASTM-E0032-21

Revision Level

2021 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

May 24, 2021

Document Type

Practice

Page Count

5 pages

Committee Number

E01.01