Document Center is acquired by Nimonik

Scope

1.1 These test procedures describe the methods of macro- etching metals and alloys to reveal their macrostructure.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents of inch-pound units may be approximate.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.2, 7.1, 8.1.3, 8.2.1, 8.8.3, 8.10.1.1, and 8.13.2.

Keywords

alloys; etchants; etching; macroetching; macroetchant; macrostructure; metals

To find similar documents by ASTM Volume:

03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)

To find similar documents by classification:

77.040.99 (Other methods of testing of metals)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.