ASTM-E394 › Standard Test Method for Iron in Trace Quantities Using the 1,10-Phenanthroline Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of iron in the range from 1 to 100 μg.
1.2 This test method is intended to be general for the final steps in the determination of iron and does not include procedures for sample preparation.
1.3 This test method is applicable to samples whose solutions have a pH less than 2. It is assumed that the pH is adjusted to within this range in the sample preparation.
1.4 Review the current material safety data sheets (MSDS) for detailed information concerning toxicity, first-aid procedures, handling, and safety precautions.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is suitable for determining trace concentrations of iron in a wide variety of products, provided that appropriate sample preparation has rendered the iron and sample matrix soluble in water or other suitable solvent (see 10.1 and Note 6).
This test method assumes that the amount of color developed is proportional to the amount of iron in the test solution. The calibration curve is linear over the specified range. Possible interferences are described in Section 5.
Keywords
iron; 1,10-phenantrholine; photometric; spectrophotometric; ICS Number Code 71.040.40 (Chemical analysis)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-E1316Standard Terminology for <?Pub Dtl?>Nondestructive Examinations
QPL-AMS-2644
Inspection Material, Penetrant
ASTM-A182
Standard Specification for Forged or Rolled Alloy and Stainless Steel Pipe Flanges, Forged Fittings, and Valves and Parts for High-Temperature Service
Document Number
ASTM-E0394-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Sept. 13, 2022
Document Type
Test Method
Committee Number
E15.01