ASTM-E518 Historical Revision Information
Standard Test Methods for Flexural Bond Strength of Masonry

ASTM-E518 - 2000A EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Flexural Bond Strength of Masonry
ORDER

Scope

1.1 These test methods cover determination of the flexural bond strength of unreinforced masonry assemblages. Two procedures are provided:

1.1.1 Test Method A -Simply supported beam with third-point loading.

1.1.2 Test Method B -Simply supported beam with uniform loading.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

flexural bond strength; masonry units; mortar; simply supported beam; stack bonded prism; third point loading; uniform load; ICS Number Code 91.060.10 (Walls. Partitions. Facades)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

91.060.10 (Walls. Partitions. Façades)

To find similar documents by Federal Supply Class Code:

FSC 5620 (Tile, Brick and Block)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E518-00a

Revision Level

2000A EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Aug. 10, 2000

Document Type

Test Method

Page Count

5 pages

Committee Number

C15.04